-
Start the seavis System Builder.
-
Activate edit mode (see Activating edit mode).
-
Open the installation wizard (see Installation wizard: Open).
-
Select the operating system (see Installation wizard: Selection of the necessary data).
-
Sending the data to Transcend 16GB Jetflash 300 USB stick (see Installation wizard: Selection of the target device).
-
Safely remove the USB stick from your computer.
-
Disconnect the HMI from the voltage.
-
Insert the USB stick into the USB port (USB 1) on the rear of the HMI.
-
Restore the power supply of the HMI.
Important
Under no circumstances should you switch off the HMI or disconnect it from the power supply during the following updating processes.
-
The operating system is updated automatically if necessary.
Under certain circumstances, the window for calibrating the touch screen appears (see HMIxxe: Calibrating the touch screen).