Switching between local / remote operation
You can choose any one of the following methods to control the burner:
It is possible to switch between local and remote operation.
If switching between local and remote operation is enabled and communication is routed via the bus, then pulse signals should be adjusted in the configuration.
Example
Pushbutton / switch
When changeover via a switch is selected, the following case may occur:
The switch is set to "Burner OFF". Remote operation is active and the burner is in operation. On switching to local operation the burner would be automatically stopped (because switch = "Burner OFF").
When you are choosing between impulse (pushbutton) and continuous (switch) signals, it is advisable to select an impulse signal.
Note
Remote operation
The corresponding input and output channels only have to be configured when the signals aren't used via signal exchange with the control system and the signals are transmitted through hardware contacts.